The board is provided with the chip set 810(E) which contains an embedded graphics controller. The DVI-I interface allows for attachment of both advanced and legacy flat panel displays and CRT monitors. The on-board USB-port is a universal interface to a variety of peripheral devices such as keyboard, mouse, printer, modem or video camera. For high speed networking, the CC5-RAVE is provided with a 10/100Mbps Fast Ethernet twisted pair jack. All connectors mentioned above are easily accessible from the cards front panel.

Equipped with a PCI-bridge chip, the CC5-RAVE offers a full CPCI interface for reliable system expansion. Especially designed for embedded systems applications, the General Software BIOS is maintained by EKF. This ensures custom specific enhancements are possible at any time.

Available as a companion board to the CC5-RAVE, the CC6-ACID is provided with all PC legacy I/O ports. This module fits on either side of the CC5, top (CC6-1 and CC6-3) or bottom (CC6-3 only), utilizing the LPC Low Pin Count interface. The card will be required only if the classical interfaces, e.g. serial and parallel port remain in use in a given environment.

The CC6-ACID can be delivered with an on-board 2.5" hard disk, resulting in a very compact system. The connectors LPT (CC6-1 only), COM1/2, mouse and keyboard are situated at the front panel, while a floppy disk drive can be attached via the on-board pin header. While the CC6-1 requires 8HP, the CC6- 3 is equipped with a 4HP front panel.

• 82810E Graphics/memory Controller Hub (GMCH)
• 82801 I/O Controller Hub (ICH0)
• 82802 Firmware Hub (FWH)

• 144-pin dual inline memory module (SO-DIMM) socket, module height 1.05inch (26.7mm) max.
• Support for up to 256MB, non ECC, unbuffered synchronous DRAM (SDRAM)
• Support for serial presence detect (SPD) and non-SPD SO-DIMMs , PC-100 style

• Ultra ATA/66 40-pin connector (primary IDE)
• CompactFlash socket for CFA ATA cards (secondary IDE), utulizing 'True IDE Mode'